Skip to main content
Daily use
AEG Support

Daily use

  1. Open the water tap.
  2. Press the on/off button to activate the appliance.

    Make sure that the appliance is in programme selection mode.

    • If the salt indicator is on, fill the salt container.

    • If the rinse aid indicator is on, fill the rinse aid dispenser.

  3. Load the baskets.
  4. Add the detergent.
  5. Set and start the correct programme for the type of load and the degree of soil.

Using the detergent


GUID-9BE6B7D0-4C37-4371-9824-4FE68B331D80-preview_v1.png


GUID-965F3119-DA02-49B7-99E4-9758009925BD-preview_v1.png

  1. Press the release button (B) to open the lid (C).
  2. Put the detergent, in powder or tablets, in the compartment (A).
  3. If the programme has a prewash phase, put a small quantity of detergent in the compartment (D).
  4. Close the lid. Make sure that the release button locks into position.

Setting and starting a programme

The Auto Off function

This function decreases energy consumption by deactivating automatically the appliance when it is not operating.

The function comes into operation:
  • 5 minutes after the completion of the programme.

  • After 5 minutes if the programme has not started.

Starting a programme

  1. Keep the appliance door ajar.
  2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode.
  3. Press GUID-C16A7C9B-435A-4D31-BD07-EA5647231C3B-preview_v1.png or GUID-0A4A99DC-F174-4F6D-A3C5-D8649F7D57F5-preview_v1.png to select a programme.
    • The indicator of the selected programme flashes.

    • The display shows the programme duration.

  4. Set the applicable options.
  5. Close the appliance door to start the programme.
    • The programme indicator stops flashing and comes on with fixed light.

    • The programme duration starts to decrease with steps of 1 minute.

If you press the on/off button before the start of the programme, the appliance will be in programme selection mode when you activate it again.

Starting a programme with delay start

  1. Set a programme.
  2. Press Delay again and again until the display shows the delay time you want to set (from 1 to 24 hours).

    The indicator of the selected programme continues to flash.

  3. Close the appliance door to start the countdown.

    The programme indicator stops flashing and comes on with fixed light.

  • When the countdown is completed, the programme starts.

  • While the countdown is running only the buttons Reset and Delay are active. It is not possible to change the programme or options.

Opening the door while the appliance operates

If you open the door while a programme is running, the appliance stops. It may affect the energy consumption and the programme duration. When you close the door, the appliance continues from the point of interruption.

icon-info.png If the door is opened for more than 30 seconds during the drying phase, the running programme will end.

Cancelling the delay start while the countdown operates

When you cancel the delay start you have to set the programme and options again.

Press and hold Reset until the appliance is in programme selection mode.

Cancelling the programme

Press and hold Reset until the appliance is in programme selection mode.

Make sure that there is detergent in the detergent dispenser before you start a new programme.

End of the programme

When the programme is completed the display shows 0:00.

All buttons are inactive except for the on/off button.

  1. Press the on/off button or wait for the Auto Off function to automatically deactivate the appliance.

    If you open the door before the activation of Auto Off, the appliance is automatically deactivated.

  2. Close the water tap.
  • Was this article helpful?