Skip to main content
Safety instructions
AEG Support

Safety instructions


Only a qualified person must install this appliance.
  • Remove all the packaging.

  • Do not install or use a damaged appliance.

  • Obey the installation instruction supplied with the appliance.

  • Always be careful when you move the appliance because it is heavy. Always wear safety gloves.

  • Make sure the air can circulate around the appliance.

  • Wait at least 4 hours before connecting the appliance to the power supply. This is to allow the oil to flow back in the compressor.

  • Do not install the appliance close to radiators or cookers, oven or hobs.

  • The rear of the appliance must stand against the wall.

  • Do not install the appliance where there is direct sunlight.

  • Do not install this appliance in areas that are too humid or too colds, such as the construction appendices, garages or wine cellars.

  • When you move the appliance, lift it by the front edge to avoid scratching the floor.

Electrical connection

Risk of fire and electrical shock.
  • The appliance must be earthed.

  • Make sure that the electrical information on the rating plate agrees with the power supply. If not, contact an electrician.

  • Always use a correctly installed shockproof socket.

  • Do not use multi-plug adapters and extension cables.

  • Make sure not to cause damage to the electrical components (e.g. mains plug, mains cable, compressor). Contact the Authorised Service Centre or an electrician to change the electrical components.

  • The mains cable must stay below the level of the mains plug.

  • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation.

  • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.


Risk of injury, burns, electrical shock or fire.
  • Do not change the specification of this appliance.

  • Do not put electrical appliances (e.g. ice cream makers) in the appliance unless they are stated applicable by the manufacturer.

  • Be careful not to cause damage to the refrigerant circuit. It contains isobutane (R600a), a natural gas with a high level of environmental compatibility. This gas is flammable.

  • If damage occurs to the refrigerant circuit, make sure that there are no flames and sources of ignition in the room. Ventilate the room.

  • Do not let hot items to touch the plastic parts of the appliance.

  • Do not put soft drinks in the freezer compartment. This will create pressure on the drink container.

  • Do not store flammable gas and liquid in the appliance.

  • Do not put flammable products or items that are wet with flammable products in, near or on the appliance.

  • Do not touch the compressor or the condenser. They are hot.

  • Do not remove or touch items from the freezer compartment if your hands are wet or damp.

  • Do not freeze again food that has been thawed.

  • Obey the storage instructions on the packaging of frozen food.

Internal light

  • The type of lamp used for this appliance is not suitable for household room illumination

Care and cleaning

Risk of injury or damage to the appliance.
  • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket.

  • This appliance contains hydrocarbons in the cooling unit. Only a qualified person must do the maintenance and the recharging of the unit.

  • Regularly examine the drain of the appliance and if necessary, clean it. If the drain is blocked, defrosted water collects in the bottom of the appliance.


Risk of injury or suffocation.
  • Disconnect the appliance from the mains supply.

  • Cut off the mains cable and discard it.

  • Remove the door to prevent children and pets to be closed inside of the appliance.

  • The refrigerant circuit and the insulation materials of this appliance are ozone-friendly.

  • The insulation foam contains flammable gas. Contact your municipal authority for information on how to discard the appliance correctly.

  • Do not cause damage to the part of the cooling unit that is near the heat exchanger.

  • Was this article helpful?